Removing an ADT panel from a wall can be a daunting task, especially if you’re not familiar with the process.

However, with the right tools and a bit of patience, you can easily remove your ADT panel and replace it with a new one.

In this blog post, we’ll guide you step by step on how to safely remove an ADT panel from a wall.

how-to-remove-adt-panel-from-wall

Step 1: Gather the necessary tools

Before you begin, you’ll need to gather a few tools to make the removal process easier.

Here’s all the items that you’ll need:

  • Screwdriver: You’ll need a screwdriver to remove the screws that are holding the panel in place.
  • Pliers: Pliers can be useful for removing stubborn screws that won’t budge with a screwdriver.
  • Wire stripper: If you need to disconnect the wires from the panel, you’ll need a wire stripper to safely strip the wires.
  • Wire nuts: Wire nuts are used to connect the wires back together after you’ve stripped them.

Step 2: Disconnect the power

Before you start removing the panel, you must disconnect the power to the panel.

If you don’t, you could get shocked or damage the panel. Turn off the power to the panel at the circuit breaker or fuse box.

Step 3: Locate the screws

The ADT panel is typically attached to the wall with screws.

Look around the edges of the panel to find the screws.

If the panel has a cover, remove the cover to access the screws.

Step 4: Remove the screws

Once you’ve located the screws, use a screwdriver to remove them.

If the screws are stuck, use pliers to help loosen them.

Set the screws aside and keep them in a safe place so you don’t lose them.

Step 5: Disconnect the wires

If there are wires connected to the panel, you’ll need to disconnect them before you can remove the panel.

Use a wire stripper to strip the ends of the wires. Then, use wire nuts to connect the stripped ends of the wires back together.

Step 6: Remove the panel

With the screws removed and the wires disconnected, you should now be able to remove the panel. Gently pull the panel away from the wall and set it aside.

If the panel is difficult to remove, make sure that all of the screws have been removed and that the wires aren’t getting caught on anything.

Step 7: Install the new panel

With the old panel removed, you’re now ready to install the new panel.

Follow the instructions that came with the new panel to install it.

If you’re not sure how to install the panel, consider hiring a professional to do it for you.


In conclusion, removing an ADT panel from a wall is a straightforward process that can be completed with a few tools and a bit of patience.

By following these steps, you can safely remove your ADT panel and replace it with a new one.

If you’re unsure about any part of the process, it’s always best to seek help from a professional to avoid damaging your panel or putting yourself in danger.

Similar Posts